4-IN-1, 4 wheel drive ball joint remover/installer kit
Perfect for 4WD ball joint service/repair. 1 "C" frame press 1 "C" frame screw
Excellent for removal and installation of press-fit parts such as ball joints. Universal joints and truck brake anchor pins
It will also remove rusted and corroded parts. High impact blow molded storage case included
Set contains C-frame press, 3 receiver tubes sizes: 2-3/4”x3"", 2-1/4”x 2-1/2” & 1-3/4”x2”, installation and removing adapters
A: Removal Adapter (1.148" L x 1/2" I.D. x 3" O.D.) B: Screw C: Installing Cup (3.676" L x 1-3/4" I.D. x 2" O.D.) D: Installation Adapter (1.122" L x 0.941" I.D. x 3" O.D.) E: Forcing-screw Press (Inner Length: 6.22"/158mm) F: Receiving Cup (2-1/2" L x 2" I.D. x 2-1/4" O.D.) G: Receiving Tube (1-3/4" L x 1-3/4" I.D. x 2" O.D.) H: Receiving Tube (1-3/4" L x 2-1/4" I.D. x 2-1/2" O.D.) I: Receiving Tube (2-1/4" L x 2.723" I.D. x 3" O.D.) J: Install Cup Adapter (0.845" L x 1.879" I.D. x 2-1/4" O.D.) To Install a Ball Joint 1. Clean the vehicle's control arm, and coat the inside diameter of the control arm with a light lubricant. 2. Insert the replacement ball joint as straight as possible into the vehicle's control arm. 3. Assemble the Ball Joint Press over the vehicle's control arm. Select the correct size Receiving Tube and position it on top of the vehicle's control arm. 4. Place the Installation Adapter between the Receiving Tube and the Ball Joint Press. Then, place the Removal Adapter between the ball joint and the Jackscrew. 5. Check the alignment of all the Ball Joint Kit parts. Then, tighten the Jackscrew until the vehicle's ball joint is firmly sealed.