RV Flag Pole Holder, Suction Cup Mount, Fits Poles up to 1.18 in — Open-Box, 15% Off

For Flagpoles up to 1.18 in: Made for poles up to 1.18 in (30 mm) in diameter; fixed-angle design is made for RVs, campers, trucks, cars and boats on compatible surfaces

Powder-Coated Aluminum Alloy: Black aluminum alloy flag holder with two 4.84 in rubber suction cups forms a removable mounting setup without drilling or permanent hardware

Clean Smooth Surfaces Only: Use on clean, dry, smooth, flat glass or painted panels; do not use on curved, textured, corrugated, wet, dusty, oily or uneven surfaces

Stationary or Low-Speed Use: Intended for parked or low-speed flag display; remove before highway driving, strong wind, rainstorms or severe weather, and check suction cups before each use

Included Hardware for Setup: Includes the rv flag holder, 2 suction cups, screws, clamps and assembly wrench; flag and flagpole are not included

RV flag pole mount holder is a removable suction cup mount for temporary flag display on RVs, campers, trucks, cars, and boats. Two 4.84 in rubber suction cups are used on compatible clean, dry, smooth, flat glass or painted panels without drilling into the vehicle surface. The powder-coated aluminum alloy holder has a fixed-angle tube and is made for flagpoles up to 1.18 in (30 mm) in diameter. Do not use on curved, textured, corrugated, wet, dusty, oily, or uneven surfaces. Before use, clean and dry the mounting area, press both suction cups against the surface, lock the levers, and check the suction cups by hand. Use for stationary or low-speed display only; remove before highway driving, strong wind, rainstorms, or severe weather. Q: What is this product? A: A removable suction cup flagpole holder for temporary flag display on compatible RV, camper, truck, car, and boat surfaces. Q: What is included? A: Holder, 2 suction cups, screws, clamps, and a hex wrench. Flag and flagpole are not included. Q: What flagpole diameter is it made for? A: The maximum confirmed diameter is 1.18 in (30 mm). A minimum grip diameter has not been specified. Q: Is the holder angle adjustable? A: No. The flagpole tube uses a fixed-angle design. Q: Does installation require drilling? A: No permanent drilling is required. The included hex wrench is used for assembly; suction cups connect the holder to the surface. Q: What surfaces can be used? A: Use only on clean, dry, smooth, flat glass or painted panels that are compatible with suction mounting. Q: Will it work on curved or textured RV siding? A: No. Do not use on curved, textured, corrugated, wet, dusty, oily, or uneven surfaces. Q: Can I drive on the highway with it installed? A: No. Remove before highway driving, strong wind, rainstorms, or severe weather. Q: Is mark-free use guaranteed? A: A mark-free result is not guaranteed. Surface marks may depend on surface finish, condition and use conditions.