On The Fly Large Manual Jack Plate for Boats, Outboard Motors up to 50hp — Open-Box, 6% Off

EFFORTLESS MOTOR LIFTING - A newly upgraded higher gear ratio lets you raise or lower your outboard in seconds with the hand crank, fine tuning engine height for speed, fuel efficiency, and handling.

SIZED FOR BIGGER OUTBOARDS - The Large unit supports motors up to 50hp, including engines with trim and tilt, giving jon boats, bay boats, and utility hulls a wider range of compatible power options.

ADJUST WHILE ON THE WATER - Change motor position at any time to run shallow flats, protect your transom from water and debris, or rebalance the load for open water cruising as conditions change.

MARINE GRADE ALUMINUM BUILD - The grey 17 x 13.75 x 5.25 in unit weighs about 30 lbs and is built to last, with a 3 year warranty on the jack plate housing and a 1 year warranty on the jack.

SIMPLE DIY INSTALLATION - Included step by step instructions walk you through mounting; pair it with stainless steel bolts and motor clamp spacers, sold separately, for a clean transom install.

The Large Manual Jack Plate from On The Fly Jack Plates is designed for outboard motors up to 50hp, including engines with trim and tilt. A newly upgraded higher gear ratio makes lifting effortless: turn the crank and your motor rises or lowers in seconds, even while you are on the water. Adjusting engine height reduces drag for better speed and fuel efficiency, protects your transom from water and debris, and lets you balance the load for the conditions. The marine grade aluminum unit measures 17 x 13.75 x 5.25 inches, weighs about 30 pounds, and installs with the included DIY instructions. Backed by a 3 year warranty on the housing and a 1 year warranty on the jack. Please review the measurements to confirm fit with your motor before ordering.