OHLECTRIC Beam Clamp for Half Inch Threaded Rod, Malleable Iron, Zinc — Open-Box, 36% Off

RIGHT CLAMP FOR THE JOB: This is a beam clamp for hanging threaded rod from structural steel, not a woodworking C-clamp. It grips the flange of an I-beam, wide-flange beam, C-channel or bar joist so you can hang conduit, pipe and equipment without drilling or welding.

FITS 1/2"-13 THREADED ROD: The tapped hole takes standard 1/2"-13 rod, and the 1-1/8" jaw opening fits beam flanges up to 1-1/8" thick. Measure your flange before ordering. Other rod sizes are in the menu on this page.

RATED FOR 750 LBS: Malleable iron body with a hardened set screw and locknut. Tighten the set screw against the flange, then lock it down so the clamp will not walk or slip off the beam edge.

ZINC PLATED FOR JOB SITES: The zinc plated finish resists corrosion in warehouses, mechanical rooms and commercial buildings. Pair it with conduit hangers, bridle rings and pipe hangers on 1/2" rod drops.

ORDER THE COUNT YOU NEED: Sold individually, so electricians, plumbers and facility teams can order the exact quantity for the run. Each clamp ships ready to install with its set screw and locknut.

OHLECTRIC malleable iron beam clamps hang 1/2"-13 threaded rod from the flange of I-beams, wide-flange beams, C-channel and bar joists, with no drilling or welding. SPECIFICATIONS: Jaw opening 1-1/8". Rod size 1/2"-13. Material malleable iron, zinc plated. Maximum load 750 lbs. Set screw with locknut. HOW TO INSTALL: Slide the jaw over the beam flange, tighten the set screw against the flange, then tighten the locknut. Thread your rod into the tapped hole and hang conduit hangers, bridle rings or pipe hangers. PLEASE NOTE: this is a beam clamp for construction and electrical work. It is not a woodworking C-clamp for gluing or furniture making. WHAT YOU GET: 1 beam clamp. Order the quantity your job needs. ABOUT OHLECTRIC: we make electrical, lighting and hanging hardware for electricians, contractors and facility teams.