MagVent MV-90 Magnetic Dryer Vent Coupling (Silver)

** Original Patented Design – Built for 90° Vent Paths** This isn't an imitation—MagVent pioneered magnetic dryer vent couplings. Our patented MV‑90 is designed specifically for 90° paths through floors, walls, or ceilings, offering a proven innovation trusted by homeowners and professionals alike.

**12" UL-Listed DryerFlex Hose** Made for safety and performance, the included 12‑inch UL 2158A-approved DryerFlex hose resists heat and fire hazards—unlike flimsy foil hoses commonly used in generic kits. Enjoy airflow efficiency without compromise.

Snap-in Magnetic Connection—Fast and Foolproof Self-aligning ceramic ferrite magnets ensure a secure, tool-free connection in seconds. Say goodbye to difficult, imprecise installations and hello to a seamless, durable setup.

Precision Fit for 90° Offsets (≥8") Engineered for cleaner installs in challenging layouts. The MV‑90 accommodates offsets of 8″ or greater, making it perfect for sidewall, floor, or ceiling vent paths—no awkward bends, no crushed hoses.

Backed by a U.S. Small Business & Real Customers Developed and supported in the U.S., MagVent stands behind the MV‑90 with real customer service, not anonymous mass imports. Trusted by thousands, our proven durability embodies commitment to quality and innovation.

MagVent MV-90 Dryer Vent & Same Wall Offsets The MV-90 is designed for when the vent path takes a 90 degree turn, such as down through the floor, up through the ceiling, or off to the side. The MV-90 can handle offsets up to 3 inches from center to center. The more accurately you line up the MV-90 with the vent on the back of your dryer, the better the vent path and the further back you can locate your dryer. Normally, the MV-90 requires 5 1/2 inches of clearance behind the dryer. If an obstruction necessitates you locate the MV-90 at the maximum 3 inch offset, then your dryer will need to sit out an additional 3 inches to allow for a bend radius in the transition duct. Close vent offsets between dryer and wall vent located on same wall as dryer: The MV-90 can be coupled directly to a standard 4 inch diameter, close 90 degree elbow which creates a 8 inch offset. If your same wall offset is 6 inches, you can use the MV-90 and an elbow, taking advantage of its ability to handle misalignment up to 3 inches. Same wall offsets greater than 8 inches: Simply mount the MV-90 directly behind your dryer, plug the 90 degree elbow into the wall vent, and measure for the required length of rigid metal pipe between them. Make sure to measure from where the pipe will stop on the MV-90 to the stop on the male end of the rigid metal pipe. Close vent offsets between dryer and wall vent located on same wall as dryer (Offsets between 0-3 inches): If your same wall offset is between 0 and 3 inches, then the MV-180 is the product for you.