Magnesium Anode Rod 44" for Hot Water Heater,Compatible with Rheemm A.O. Smithh Giantt,Reliancee Richmondd,Hex Head 3/4" NPT x 44" Corroation Protect Rotten Egg Smell for Home Water Tank — Open-Box, 26% Off

REMOVE ROTTEN EGG ODOR FROM WATER:Our anode rods are made from high-quality magnesium and work through a sacrificial anode reaction to effectively eliminate unpleasant rotten egg odors (hydrogen sulfide) from your water heater. This helps improve hot water quality and ensures a cleaner, more comfortable shower experience

PROTECT YOUR WATER HEATER FROM CORROSION:The magnesium anode rod provides reliable corrosion protection for the inner tank by attracting corrosive elements in the water. This helps prevent rust damage, extend the lifespan of your water heater, and reduce the risk of costly repairs

EASY-CUT DESIGN:The 44" length with easy-cut design allows you to trim the anode rod with a hacksaw, making it ideal for tight installation spaces such as utility closets, crawl spaces, or under-sink water heaters where standard rods may not fit

UNIVERSAL FIT FOR MOST WATER HEATERS:Compatible with most major water heater brands including Rheem, A.O. Smith, Giant, Reliance, Richmond and many others that use a standard ¾" NPT anode rod connection, ensuring a secure and reliable replacement

EASY INSTALLATION & IDEAL REPLACEMENT:This hot water heater anode rod is designed for straightforward installation. With just a wrench and basic tools, you can quickly replace your existing rod. Regular replacement helps extend heater lifespan, improve water quality, reduce odors, and minimize maintenance costs

8 steps to replace anode rod: 1. Turn off the power. Flip the circuit breaker to the water heater on the electrical panel. Use a non-contact voltage tester on the water heater to ensure it is off. 2. Dig out the foam insulation around the old anode rod and vacuum out the loose bit. 3. When the water supply is on, drain a few gallons (about 5.7 L) to flush the bottom of the tank, then turn off the water supply and allow more gallons to drain. 4. Remove the old socket using a 1 1/16 impact sleeve and a corded impact gun (using an impact gun is so easy). 5. Place the old rod in the recycling. 6. Wrap Teflon tape around the top thread of the new rod about four times. 7. Place the new rod in and tighten it using an ordinary old socket wrench. 8. Turn on the water supply, then turn on all hot water faucets around the house for about 30 seconds each. Let the hot water faucet run a little to remove air from the system, and if there is air in the water heater, it can protect you from blowing out elements