KS TDP Far Infrared Mineral Heat Lamp w/a Detachable Head Floor Model (KS-9800F) — Open-Box, 8% Off

This model features a traditional heating coil (NOT a heating tube). Traditional heating coils are designed to deliver reliable performance and stable, consistent heat.

The heat produced by our Infrared heat lamp does not utilize high heating temperature, yet still allows excellent Infrared penetration through the skin.

TDP works with coil heat and a mineral plate (no light bulb needed). The Mineral Plate (6.5" in diameter, life span of up to 1,500 hrs) emits Far Infrared Rays when heated.

Please wait at least 15-20 minutes for heat. Typical sessions should last a minimum of 30 min per area.

110V Detachable head - simply unplug the cord that connects the head and the main frame when replacing.

It is equipped with reliable mechanical controls (a power switch and a mechanical timer dial) for easy operation. The externally located fuse allows for quick and convenient fuse replacement when needed.

1) Please note that the heat lamp will take approximately 15 minutes to warm up. After preheating for 15 minutes, please allow an additional 5 minutes for the temperature to increase. 2) As a general guideline, the distance between the surface area and the heating head should be approximately 12 inches. Actual positioning of the TDP head may be adjusted to reach the desired level of heat. Do not position the lamp head too close to the skin. 3) A minimum of 30 minutes per session on the targeted area is recommended. Please note that the duration for a given session may vary depending on the condition. 4) The heat lamp only provides warmth. Please do not expect a higher temperature range as higher temperatures may cause the skin to overheat and burn. Higher temperature ranges will not increase the effectiveness. Replaceable/detachable head *NOTE: WARRANTY INFORMATION 6 Months Limited Warranty on Labor Only, and 3 Months Limited Warranty on Parts. NO warranty on TDP heads. Freight cost is not included in the warranty.