BALLISTA 16" Sting Helical 3-Vane Crossbow Bolts for Hawkwing, 6mm OD, 3pc — Open-Box, 46% Off

Purpose-Built for BALLISTA Hawkwing. 16 in, 6mm OD Sting bolts are tuned for Hawkwing crossbows with spine 400, 361 gr total weight, and 90° half-moon nock alignment. Not for BAT or BAT Reverse models.

2.5° Helical 3-Vane Flight. Three 1.75 in white vanes use counter-clockwise helical offset to start rotation early, helping stabilize field tips or compatible broadheads for target practice and hunting.

Micro-Diameter Carbon Shaft. Slim 6mm OD carbon shaft helps reduce drag and wind drift, supporting flatter downrange flight and stronger penetration than standard-diameter arrows in compatible Hawkwing setups.

120 gr Stainless Penetrator Insert. Front-weighted stainless insert supports FOC balance and accepts standard 7.6mm field tips and broadheads; steel field tips are included for out-of-box use.

Ready 3-Pack, No Assembly. Includes 3 fully assembled bolts with steel field tips; storage case and broadheads are not listed as included. Frequent shooters may want more than one pack.

Factory Nock Safety. Keep the factory half-moon nocks on Hawkwing. Do not install lighted or lightweight nocks on Hawkwing or other 350-400+ FPS setups; inspect every bolt before reuse.

BALLISTA 16 in Sting Helical 3-Vane Carbon Crossbow Bolts are purpose-built for BALLISTA Hawkwing crossbows. The 6mm micro-diameter carbon shaft, 361 gr total weight, spine 400 construction, and 90° half-moon nock alignment are tuned for the Hawkwing platform, not for BALLISTA BAT, BAT Reverse, or standard-diameter bolt setups. Each bolt uses three 1.75 in vanes set at a 2.5° counter-clockwise helical angle to start rotation early and support stable flight. The slim 6mm OD shaft helps reduce drag and wind drift, while the 120 gr stainless penetrator insert adds front-of-center balance and accepts standard 7.6mm field tips and compatible broadheads. The pack includes 3 fully assembled bolts with steel field tips. A storage case and broadheads are not listed as included. Bolts can be reused only after inspection; replace any bolt with shaft cracks, loose inserts, damaged vanes, or nock wear. Important setup note: keep the factory half-moon nocks on Hawkwing bolts. Do not add lighted or lightweight nocks for Hawkwing or other high-speed crossbow setups above 350-400 FPS unless the crossbow manufacturer specifically approves that combination.