ALLSAFE 4-Ft Pool Fence Gate Mesh Replacement, 46.5 x 30 in — Open-Box, 19% Off

Made to Fit Your 4-Ft Gate – Cut to 46.5 x 30 inches, the exact mesh opening on a 4-foot gate frame. It sits a little lower than the fence beside it because the gate swings on hinges with clearance underneath.

Just the Mesh, Ready to Fit – A finished panel with a sewn border on all four edges, so there is no cutting or hemming. Mesh only: the gate frame, hinges and latch are not included.

Quick Repair – The pool safety fence gate comes partly apart to swap the panel, then goes back together on the same hardware. Check the instructions and your frame size before ordering.

Tensioned for a Flat, Clean Finish – The panel is cut to stretch, so it looks small until it is on. Pulled firm and even, it sits flat across the frame with no sag or bowing.

Built for Gates – Sized for gate frames rather than fence runs, and finished to size so it arrives ready to fit straight out of the box.

Malibu Black, 10 x 10 Weave – Textilene woven at 10 x 10 squares per inch in Malibu black. Pool fence mesh comes in more than one weave, so check your current gate panel before ordering if you want the replacement to match the rest of the fence.

Frame Size Compatibility – Fits frames with a 46.5 x 30-inch mesh opening, ALLSAFE or another brand. Measure your existing panel or frame to confirm, since gate sizes vary between systems.

Repair Instead of Replace – A torn panel does not mean a new gate. Reuse the frame, hinges and latch you already have.

A torn or damaged mesh pool gate panel does not mean buying a new gate. This ALLSAFE replacement mesh fits the gate frame you already have, so the frame, hinges and latch stay where they are and the gate goes back to looking the way it did. The panel measures 46.5 inches high by 30 inches wide, which is the mesh opening on a 4-foot pool fence gate. It is shorter than the 4-foot fence beside it for a reason: a gate hangs on hinges and needs clearance underneath to swing freely, so the frame sits a little higher off the ground than the fence line. The mesh is sewn for the frame and pulled taut across it during installation. The mesh is PVC-coated, UV-resistant polyester in Malibu Black, with a 10 x 10 weave that keeps a clear view of the water and matches the mesh used across the rest of an ALLSAFE fence. All four edges are finished with a sewn border, so the panel arrives ready to fit. Fitting it is a straightforward job. The gate comes apart so the old mesh can be released, the new panel goes on, and the hardware goes back together. The mesh needs to be pulled firm and even on all sides, and a second pair of hands makes it easier to hold tension and keep the alignment square. It will look small held loosely against the frame; that is expected, and the tension is what gives it a flat, clean finish. Before ordering, measure the mesh or frame on your existing gate and confirm the attachment style, since gate sizes vary between systems. This panel fits any frame with a 46.5 x 30-inch mesh opening, whether the gate is an ALLSAFE one or another brand. What you receive: one 46.5 by 30 inch Malibu Black gate mesh panel with a finished sewn border. The gate frame, posts, poles, hinges, latch, screws and other installation hardware are not included. This is a gate panel and not a 15-foot fence section.