Battery Board,10S 36V 30A BMS PCB Board with Balance Function for Li-ion Battery Cell,for Electric Car, Electric Power Assistant Car, Skateboard Car, — Open-Box, 60% Off

✔ 10S lithium-ion battery: The board is for 10-cell Li-ion batteries, it can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries. ✔ 10S lithium-ion battery: The board is for 10-cell Li-ion batteries, it can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries. ✔ 10S lithium-ion battery: The board is for 10-cell Li-ion batteries, it can be used for 3.7V ternary batteries, manganese acid batteries and cobalt acid batteries. ✔ Balance Function: PCB BMS has a balance function which can ensure that each cell of the battery is fully charged at the same time. ✔ Multifunctional : The battery supports against overcharging, against discharging and against short circuit, safe and

Specifications:

Applicable voltage: 36V

Applicable power: <1000w

Maximum working current: 30A

Continuous maximum current: 20A

Overdischarge voltage: 2.6v

Overcharge voltage: 4.25v

Charging current: Maximum 10A

Balance voltage: 4.2v

High temperature discharge: 75 ℃

Low temperature : - 7 ℃

Weight: 46g

BMS Board Wiring Steps

1. Firstly connect the batteries in series

2. Ensure that the voltage of each string is the same (the difference between the highest voltage and the lowest voltage is preferably within 0.1V), and the voltage range is between 3.2-4.0V.

3. Firstly connect the distributed cable, connect according to the diagram, and insert the cable port into the board port after checking it is correct (first connect the battery, then insert the board, the step cannot be reversed).

4. Check whether the total positive voltage of the C-port and P-port to the battery is equal to the total voltage of the battery. If they are equal, the board is working normally.

5. Solder the battery negative B- to the port marked B- on the board.

6. Both the battery output negative electrode and the charging negative electrode of the same port board are connected to the port marked C- on the board (the P- port is just floating).

7. Separate port (different port) board, the battery output negative pole is welded P-, and the charging negative pole is welded into the port marked C- on the board.

Package included:

1 x Board

1 x Cable

Note:

Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.